User’s manual · MAX IP90
Technical changes and mistakes reserve
-
9
-
MAX IP90 Version en_1.0
FTE Maximal
Network Configuration
The receiver will require the introduction of the needed parameters to be able to
get connected to a network, as well as to be visible to other equipments so that
receive streaming of video and audio.
You should introduce the following parameters:
IP Address
Number of 32 bits expressed in 4 numbers between 0
and 255 which identifies the receiver inside its network.
Every device in the network should have a different IP
Address and it is highly recommended that all of them
are in the same subnetwork and with IP addresses into
the following range:
10.x.x.x
172.16.0.0 – 172.31.255.255
192.168.x.x
Subnet Mask
Number in IP format that, combined with the IP address, identifies where the equipment is.
IP LAN Soft:
IP address of the PC where the application for exchanging video streamings between the
PC and the receiver is installed.
If you want, you can download the application
IP LAN Soft
from the Website:
www.ftemaximal.com
MAC
Device address at hardware level. It is unique in each device and it comes from the factory.
You can move through the menus with the buttons
and
.
With the
Red
button you delete the last character.
Press
OK
to save the changes.
Search IP Channels
The receiver will carry out a search for channels broadcasted by other equipment
connected to the network.
You can receive transmissions of other equipment in mode
Unicast
and
Multicast
.
- Unicast
is when the information is sent from a unique sender to a
unique receiver.
- Multicast
in when the information is sent through a network to multiple
destinations simultaneously. The equipment that work in multicast mode
send the information into an IP range between 224.0.0.0 and
239.255.255.255.
In
Search Type
select
Auto
to search for all the channels which are broadcasted
by other equipment in your network in multicast mode. If you select the
Host
option, it will look for transmissions of the equipment present in the list
Network
Management
that you select.
In the field
Multiplex
you should select the hosts from the list Network
Management in which you with to search for channels.
Pressing the
Blue
button or
a new window will appear, where you can select
the hosts.
You can move the cursor with
.
With the
Green
button you select the hosts.
Press
Exit
to go back to the search menu.
If you press the
Green
button, it will carry out a search of the video IP channels.
Press
Exit
to exit.
The
Fast install guide
is now finished.
