FTE Maximal GENIUS PRO 200, User Manual

Page: 74 / 100

User’s Manual · Genius
Reserved for technical modifications and/or errors
-
6
-
Genius Version en_1.5 FTE maximal
Chapter 2.
Menu and programming the amplifier
The programming of the amplifier is through the PRO 200 / PRO 201 external programmer. Below the steps and the
menu options are explained:
2.0.- MAIN MENU
The main menu contains the following options:
- Inputs: to programme the channels in each input.
- Prog CH: to programme the filters.
- Back-up: Options for the data management, backup and restore
- Auto: To enable AGC and Autolevel.
- Info: Information about Software and Hardware versions are shown.
- Standard: to select the modulation Standard.
We will move through options with keys “Up” and “Down” of the keyboard.
OK to confirm and CANCEL to go back.
To enter in the menus Inputs and Prog CH, you should have the AGC option in OFF at the AUTO Menu.
2.1.- 1st Step: Menu Inputs
In this menu the UHF inputs will be programmed.
On the display, 3 columns appear for configuring the channels in each input. In
the first row the name of the inputs are shown (UHF1, UHF2, UHF3), in the
second row the filters that we’re going to assign and in the third row the voltage
to feed previous amplifiers that we select.
The selection of the input configurations is sequentially, following the table shown below, it is, with the keys < > you will
see the possible configurations. In the same manner, the output voltage for previous amplifiers is selected to 12 Vdc or
24 Vdc for the 3 inputs simultaneously. The system is protected against shortcuts, in case of detecting a shortcut, the
central cuts the current at this input.
If we are in UHF1, we will move using the keys “right” and “left”, depending on the combination of channels we want to
programme. Possible combinations:
- Possible combinations for Genius 10
FILTERS
INPUTS >
COMBINATIONS
V
UHF1 UHF2 UHF3
1(*) 1-3 4-8 9-10
2(**) 1 2-8 9-10
3 - 1-8 9-10
4 1-3 - 4-10
5 1 - 2-10
6 - - 1-10
(*) Detail of the configuration:
4 7
2
3 5
10
6 8 1 9
UHF1 UHF2 UHF3
GENIUS ICT
>Inputs< Back-up
Prog CH Info
Auto Standard
GENIUS ICT
UHF1 UHF2 UHF3
>1-3 4-8 9-10<
12V 12V 12V