FScurtis FAC-52B, Instruction Manual

Page: 43 / 63

5.Periodic Inspection/Maintenance
5-10
A110571
5.5.9 Change air filter element
[Every 500 hours]

Air filter is an important part which is crucial to machine's performance and life.
Be sure to use genuine parts.
<Procedure>
①
After removing the cap “1” by loosening its latch
“2”, clean its interior properly.
②
Remove the element “3”, “4” and then replace it
with a new one.
(For part number, see 5.4)
③
When installing cap “1” after replacing it, hold
O-ring “5” to the case “6” with a hand so that
O-ring “5” may not come out, and then tighten it
after confirming that the hook of cap fixing latch
“2” is engaged.
5.5.10 Clean of element in sedimenter
[Every 500 hours]
<Procedure>
①
Turn fuel selector valve “1” to “OFF” position.
②
Loosen the drain valve “2” and drain out condensed
water inside.
③
Turn the cup “3” to the left and remove it.
Be careful to remove the cup “3”, because it is filled
with fuel. Wipe out split fuel completely.
④
Remove float “4” inside cup “3”.
⑤
Washing element “5” and the cup inside with new
fuel.
⑥
Replace element “5” and o-ring “6”, “7” if they are
found broken or damaged.
(For part number, see 5.4)
⑦
After finishing clean, assemble it in reverse
procedure.

If air is found still in fuel pipe, place starter switch
to “RUN” position and loosen air bleeding bolt “8” to
bleed air. After finishing air bleeding, tighten the air
bleeding bolt “8”.

Drain the condensate in container “9”, and then
dispose of condensate according to the designated
regulations.
Use our genuine part
A100117
1 8
7
6
5
3
4
2
9
ON
OFF
2
1
4
4
1
2
3
6
6
(For engine)
3
5
(For compressor)