Step 4: Click “WLAN” in “Network” to select whether to enable wireless. And you can also modify
the wireless name, authentication mode and password.
Step 5: Click “Apply Changes” to proceed to the next step.
If you want to use the wireless network, please make sure your PC is equipped with the wireless
adapter card, then do as following steps. Here takes Windows 7 System as an instance:
Step 1: Select “Network” and “Properties”
System Setting
10
EN
Status
LAN
WLAN
Service
Admin
wlan0 (2.4GHz)
Basic Settings
WLAN Basic Settings
This page is used to configure the parameters for WLAN clients which may connect to your Access Point. Here you may
change wireless encryption settings as well as wireless network parameters.
Disable WLAN Interface
2.4 GHZ(B+G+N)
Security
Advanced Settings
Access Control
SSID:
2.4G-F58A
AP
Mode:
Channel Width:
20MHz
Control Sideband:
Channel Number:
Auto
Radio Power (%):
Status
100%
MESH
Site Survey
WPS
wlanl (5GHz)
Disabled
Limit Associated Client
Number:
Associated Clients:
Show Active WLAN Clients
Enable Universal Repeater Mode (Acting as AP and client simultaneouly)
Apply Changes
Upper
Multiple AP
Band:
network
Open
Pin to Start
Map network drive...
Disconnect network drive.…
Create shortcut
Delete
Properties