Module1
Dual-power input:
The switch can be powered by one power module, or two power modules. When both two modules
are available, the switch is powered in load-balanced state.
Installing the Power Supply Module
2. Remove the blank panel and take the plane printed with power information as the top panel of
the power module. Hold the handle of the power module with one hand, and hold the end of the
power module with the other hand. Insert it into the chassis along the guide rail uprightly and
slowly until it clicks into place, and make sure that it is in good contact with the power slot.
1. Take a new power module out of the package and confirm the input mode and the input
parameters of the power module match the requirements.
NOTE:
When the switch is powered by the dual-power modules, if the system working
power is greater than the capacity of single power module, power redundancy cannot
work.
100-240v
-;50/60H
z;7-3.5A
Input
Output
Status
M1SFANI-F
Status
M1SFANI-F
Status
PWR1 PWR2
Input
Output
