FS M6500 Series, Configuration Manual

Page: 158 / 185

M6500 Series NE Configuration Manual
157
(1) When optical module is not inserted into the port, the optical module is not in position but the port is
enabled.
(2) Optical module is inserted into the port but it is mismatched and the port is enabled.
At this time, all the non-time stamp data will be shown as -,and all the time stamps will be shown as ----/--/--:--:--.
The suspicious interval marker is untrustworthy. The running time is normal and counts from 0, as shown in the
figure below:
Figure9-34 Optical Module of FEC Not In Position
Here are the situations when the monitoring data for the board is shown as -:
(1) When the board is not in position or is pre-configured with an empty slot and the port for the board is
enabled, all the non-time stamp data will be shown as -,and all the time stamps will be shown as - /-:--.The
suspicious interval is marked as untrustworthy, and the running time is always 0 without any change, as shown
in the figure below.
Figure9-35 FEC Monitoring Data
(2) When the board is mismatched and the port for the board is enabled, all the non-time stamp data will be
shown as - and all the time stamps will be shown as ----/--/--:--:--. The suspicious interval is marked as
untrustworthy, and the running time counts from 0, as shown in the figure below:
Figure9-36 FEC Monitoring Data When Mismatched
9.2.4. OTUk/ODUk Current Performance Statistics
9.2.4.1. OTUk/ODUk Monitoring Parameters Introduction
As shown in the figure, the monitoring parameters of OTUk/ODUk monitoring points include background error
block (BBE), error second (ES), serious error second (SES), unavailable second (UAS), suspicious interval marker,