Step 5: Click the
System Mode Switch
to switch the FIT/FAP working mode.
Configuring the AP Using the Console Port (FAT AP Mode)
Step 1: Connect a computer to the AP's Micro USB port using the console cable.
Step 2: Start the terminal simulation software such as HyperTerminal on the computer.
Step 3: Set the parameters of the HyperTerminal: 9600 bits per second, 8 data bits, no parity,
1 stop bit and no flow control.
Step 4: After setting the parameters, click
Connect
to enter. And then enter the default
password,
admin.
Protocol:
Serial
Flow Control
DTR/DSR
RTS/CTS
XON/XOFF
Save session
Open in a tab
Cancel
COM3
9600
8
None
1
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Show quick connect on startup
x
Quick Connect
The port may be manually entered or selected from the list.
Connect
Connect
NOTE:
The access points work in Fit AP Mode by default.
x
System Mode
Fit AP Mode
AC
AP
AP
CLLENT
POE SW
Internet
Fit AP Mode
AP
ROUTER
CLLENT
POE SW
Internet
Current Mode: Fit AP Mode
NOTE: The device restarts after mode switch. please wait for a minute.
