Fruitland RCF 1200, Operation And Maintenance

Page: 17 / 64

17
Fruitland Manufacturing • Toll Free: 1-800-663-9003 • www.fruitlandmanufacturing.com
ATTENTION
Fruitland Vacuum Pumps should never exceed the input RPM stated
on the vacuum pump’s plate tag - severe pump & system damage
will occur & the pumps warranty will be void.
Fruitland pumps may be run up to 20% slower than the stated RPM on the
tag if required.
ATTENTION
Vacuum pump & drive system direction of rotation must be deter-
mined and verified prior to procurement of the vacuum pump and
all correlating drive system components.
The largest contributing factor limiting a Fruitland Vacuum Pumps performance is continued
heat generation due to operating the pump above and or below the recommended input
speed. This additional heat produced due to incorrect RPM Input speed will negatively impact
the overall life of your Fruitland pump.
Check the Drive Components of the Vacuum Pump
If using a Fruitland right-angled gearbox verify the gear oil level within the gearbox and clean
the vent cap upon the top of the gearbox case during your routine service.
If using a belt and pulley to operate the vacuum pump, check the belts for wear and verify the
belt’s tension during your routine service.
When incorporating hydraulics ensure the fluid is replaced on a routine basis as the viscosity
deteriorates in the same fashion as your engine oil.
Contact the factory for the optimum hydraulic circuit, gearbox and belt specifications
for your vacuum pump system.