1
FrSky SBUS to PWM Decoder
Instruction Manual
Thank you for purchasing FrSky SBUS to PWM Decoder. This product can be used to
decode SBUS signal to PWM signal for conventional analog or digital servos with SBUS
receivers. In order to fully enjoy benefits of this system, please, carefully read the
instruction and set up the devices as described below.
Specifications
Channel Output Cable Lengths
: 210mm
Total length
: 350mm
Weight
: 14.8g
Operating Temperature Range
: -10-80
Ԩ
Operating Voltage Range
: 4-10V
Compatibility for SBUS Connection Port:
FrSky SBUS Servo Channel Changer, FrSky
TFR8SB receiver, Futaba SBC-1 or Futaba S.BUS receivers (R6208SB, etc.)
Compatibility for PWM Connection Ports
: conventional analog or digital servos
Warning: DO NOT connect the battery power HIGHER than the operating voltage of
connected servos, otherwise injury or damage may occur.
Channel
Setting
Methods
Use FrSky SBUS Servo Channel Changer, FrSky TFR8SB receiver, Futaba SBC-1 or
Futaba S.BUS receivers (R6208SB, etc.) to finish the channel settings.
Warning: DO NOT connect any servo to the PWM servo connection ports during
channel setting procedures. FrSky are not responsible for any damage or injury
caused by incorrect operation.
*
Channel Setting with FrSky Servo Channel Changer:
a. Connect the SBUS connector of FrSky Decoder to the servo connection port of
FrSky SBUS Channel Changer.
b. Connect the battery to the battery connection port of FrSky SBUS Channel
Changer.
c. Press briefly the button on the Decoder and select the servo connection port
number that you want to set channel (see LED number and PWM servo
connection port number for details).
The selected servo connection port number will be displayed as “servo channel number
before set” on FrSky Servo Channel Changer.
d. Use the roller switch to set the channel number after “Set-to” to the one you
require.
e. Select “SET” and push the roll switch to confirm the channel setting. After the two
channel numbers are the same, channel setting procedure is completed.
f. To set channels for other servo connection ports, repeat from step c to e.
* Channel Setting with Futaba SBC-1:
a. Connect the SBUS connector of FrSky Decoder to the S.BUS servo connection
port of Futaba SBC-1.
b. Connect the battery to the battery connection port of Futaba SBC-1.
●
Do not connect SBUS connection port to other device other than FrSky SBUS
Servo Channel Changer, FrSky TFR8SB receiver, Futaba SBC-1 or Futaba S.BUS
receivers (R6208SB, etc.)
●
Do not connect any device other than analog or digital servos the PWM servo
connection ports.
●
Do not disassemble or modify the product
. FrSky are not responsible for man-
made damage caused by improper set up, or replacement if disassemble or modification
have been made.
