USB Charger
Prepare your Quadcopter
1. Install the propellers
Fix the clockwise propellers onto the clockwise motors,
following the rotation direction that marked on the motors. And then,
fix the
counterclockwise propellers in the same way. Tighten the propellers manually and make sure the propeller is installed in the proper way
and fastened.
2. Install the battery
Put the battery into the bottom of the body and move it forward-backwards as required for perfect balance.
Note: Make sure the battery installed in a suitable place so that the quadccopter has a best balance.
Ready for flight
1. Place the Apus MQ60 V2 in a wide open space, with the rear facing you.Turn on the radio first and power on the Apus MQ60 V2.
2. Put all the switches in the remote controller to the UP position, center all the trim buttons and function buttons and move the throttle
to the lowest position.
3. If you have a video receiver (such as a monitor or goggles) please turn on the receiver and view the video transferred by the MQ60.
End of flight
1. Land the aircraft, disarm (lock) the aircraft.
2. First power off the aircraft by unplugging the battery, then turn off the remote controller.
3. Finally, remove the battery from the aircraft.
Operation instruction
Remote Controller control instruction
Aircraft posture ( the direction of head)
MODE1/MODE2
YAW (turn)
Left/right
The YAW channel
controls the left or
right rotation of
the head of the
drone.
MODE 1
(Throttle stick on the right)
MODE2
(Throttle stick on the left)
PITCH
Forward/backward
The pitch channel
controls the forward
and backward of
the drone.
MODE1/MODE2
ROLL (lean)
Left/right
The roll channel
controls the left
or right flight of
the drone.
MODE 1
(Throttle stick on the right)
MODE2
(Throttle stick on the left)
THROTTLE
Up/down
The throttle channel
controls the up and
down of the drone.
FrSky is continuously adding features and improvements to our products. To get the most from your product, please check
the download section of the FrSky website www.frsky-rc.com for the latest update firmware and manuals.
Instruction manual for Apus MQ60 V2
Instruction manual for Apus MQ60 V2
A
5865
5845
5825
5805
5785
5765
5745
B
5733
5752
5771
5790
5809
5828
5847
5866
C
D
5740
5760
5780
5800
5820
5840
5860
E
5732
5769
5806
5843
F
CH
Band
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
Charge the battery
1. Connect the charger to the USB adaptor
2. Inserting the battery to the charger (To make better use of the battery, it is recommended to charge it at 4.35V)
3. The LED will keep red when the battery is charging and it will go out when the battery is fully charged.
