Figure
15
Figure 1
6
Apply a solution of soapy water to all connections to check for leaks. If soap bubbles continue to form,
the connection has a leak. If a leak is found, close the tank valve and tighten all connections.
NEVER USE A FLAME TO CHECK FOR LEAKS.
Stick the conversion label on the rating plate as shown in Fig. 1
7
.
Figure 1
7
LIGHTING INSTRUCTIONS
1. Locate the control and igniter panel. Make sure the control knob is in the “OFF” position. See Fig.
1
9
. Open the tank door and open the tank valve all the way.
2. Push in the igniter button. You will hear a slight clicking sound. With the igniter button pushed in,
push and turn the control knob to the “ON” position. The fire should light within
a few seconds. Once the flame is lit, release the igniter button and continue to hold the control knob
in for 10 to 15 seconds. Release the control knob. The control knob should pop back out and the fire
should remain lit. Note: If the fire does not light, turn the knob to the “OFF” position and wait five
(5) minutes before trying again.
3. To turn down the flame, push the control knob in slightly and turn to the Medium (medium flame)
or Low (small flame).
4.
To shut down the fire pit, turn the control knob to the “OFF” position and turn off the tank valve
9
