Frontgate 141267 MUL, Manual

Page: 15 / 15

TO REPLACE LIGHT BULBS
CAUTION:
FIRST UNPLUG YOUR PRODUCT FROM ANY POWER SOURCE.
1. To reduce the risk of overheating, replace burned-out light bulbs promptly. Use only
2.5 volt light bulbs only.
2. Grasp plug and remove from the receptacle or any other electrical outlet device. Do not
unplug by pulling on the cord.
3. Pull the light bulb and its attached plastic base straight out of light bulb holder.
4. Replace light bulb with only 2.5 volt super bright type light (provided with product).
5. If the new lamp base does not fit the replacement light bulb, follow the steps below
before step 4.
a. Remove the base of burned out light by straightening light leads and gently pull bulb out.
b. Thread metal leads of new lamp through hose in old base with one lead in each hold.
c. After lamp is fully inserted into base, bend each lead up, like other lights in the light set so that the leads will touch the
contacts inside the light socket.
TO REPLACE A FUSE:
CAUTION:
FIRST UNPLUG YOUR PRODUCT FROM ANY POWER SOURCE.
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by
pulling on cord.
2. Open fuse cover. Slide open fuse access cover on top of attachment plug towards plug’s
metal prongs or blades.
3. Remove fuse carefully.
4. Risk of fire. Replace fuse ON LY with 3 Amp 120 Volt fuse. (Provided with product).
5. Close fuse cover. Return the sliding fuse cover back to its former closed position on
attachment plug.
6. Risk of fire. Do not replace attachment plug because it contains a safety device (fuse)
that should not be removed. Discard product if the attachment plug is damaged
Please contact one of our Product Specialists for assembly assistance or questions at 1-800-537-8484 or email ps@frontgate.com.
Specialists are available weekdays 8:00 a.m. to 8:00 p.m. EST or Saturday 9:30 a.m. to 6:00 p.m.
OPEN
OPEN
FUSE COVER
SLIDES FORWARD
3 AMP
120 VOLT
FUSES
PULL BULB UP
TO REMOVE
PUSH BULB DOWN
TO REPLACE
USER INSTRUCTIONS