TBRA030_REV_A04
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE
2
2.1
2.2
2.3
If your vehicle has a door that opens to the
left side, you need to reposition the two
Stopper Screws. Do this by removing them
from the left side of the Sliding Board and
refitting them on the right side as shown in
Step 2.1.
If your vehicle has a door that opens to the
right side, move on to Step 2.2.
Drill 5mm pilot holes on the marks made,
using light pressure and taking care
only to drill through the interior panel. Open
the holes to 12mm.
Stopper
Screw
6mm
5mm
12mm
Find a suitable flat surface for the table.
Before marking, make sure that the Sliding
Board can slide out of the table without
any interference .
FOR JEEP JK INSTALLATION
If you are fitting the Drop Down Table to a
Jeep JK, refer to Step 2.2 for positioning.
Remove the trim panel if fitted.
Close the rear door and place the table on the
floor inside the Jeep with the back of the table
against the inside of the door.
Move the Drop Down Table as far to the right
as possible as shown in 2.2.
Open the table and mark out the four fixing
points shown in 2.3.
