© COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
4
FATT002_REV_A01
4
FIT AND SECURE
2
13mm
2.4
2.5
2.6
Clean the area around each mounting
point using a rag and denatured alcohol.
Place a small amount of silicone over
each mounting point followed by one of
the aluminium spacers supplied as
shown. There are ten spacers in total.
The shorter spacers (item 6) must be
used on the two middle mounting points
and the longer spacers (item 11) must be
used on the front and rear mounting
points on either side of the vehicle.
Refit the ditch molding, lining up the
holes in the ditch molding with the
aluminium spacers.
Using a 22mm hole punch
(Recommended) or hole saw, punch/drill
holes through the ditch molding on each
of your markings.
Refer to step 2.2.
