62
CAUTION!
Risk of injury from hot system components.
► Before starting work, allow all hot system components to cool to room temperature,
such as:
Torch body
Torch body coupling
CAUTION!
Risk of injury from compressed air escaping from the torch body coupling, flying de
-
bris, and sharp components.
► Always wear the following protective equipment when carrying out the work described
below:
Safety glasses with side guards
Gloves - electrically insulating and heat protective
Protective helmet
Maintenance ac
-
tivities
NOTE!
Perform daily visual inspection!
Daily visual inspection is mandatory.
► The interface between the torch body and the torch hosepack must be clean, dry, and
free from grease and mechanical damage such as scratches or scoring.
If coolant leaks:
-
Check all coolant-carrying components
-
If necessary, change the water stops on the torch body
-
Check that O-rings are intact and greased;
If necessary, replace and grease the O-rings.
-
Check the position of the robot in relation to the torch-body rack according to the pro
-
gram sequence.
Changing the O-
rings in the Torch
Body Coupling
Remove the torch body from the torch body coupling
Unscrew the torch body coupling from the drive unit/the hosepack
5
Fit the torch body coupling to the hosepack/drive unit correctly
1
2
3
4
