56
Digital input signals (signals from robot)
Parameters
Signal level:
-
LOW (0) .. 0 - 2.5 V
-
HIGH (1) .. 18 - 30 V
Reference potential: GND = X7/2 or X12/2
Welding start
The “Welding start” signal starts the welding process. The welding process remains active
while the “Welding start” signal is present.
Exception:
-
The digital "Power source ready" output signal is absent
NOTE!
All signal states refer to the interface input, not the robot control.
Pin X2/4
HIGH
Summary of Contents for TransPocket 3500
