8
For the location of the safety and danger notices on the device, refer to the section headed
"General" in the Operating Instructions for the device.
Before switching on the device, remove any faults that could compromise safety.
Your personal safety is at stake!
Intended Use
The device is to be used exclusively for its intended purpose.
The device is intended exclusively for the welding process specified on the rating plate.
Utilization for any other purpose, or in any other manner, shall be deemed to be "not in ac-
cordance with the intended purpose." The manufacturer is not responsible for any damage
resulting from improper use.
Proper use also means
-
Completely reading and obeying all instructions in the Operating Instructions
-
Completely reading and obeying all safety instructions and danger notices
-
Carrying out all the specified inspection and servicing work
Never use the device for the following applications:
-
Thawing pipes
-
Charging batteries
-
Starting motors
The device is designed for operation in industry and business. The manufacture shall not
be liable for any damage resulting from use in a living area.
The manufacture shall also not be liable for faulty or incorrect work results.
Environmental
Conditions
Operation or storage of the device outside the stipulated area will be deemed as not in ac-
cordance with the intended purpose. The manufacturer accepts no liability for any damage
resulting from improper use.
Temperature range of the ambient air:
-
During operation: -10°C to +40°C (14°F to 104°F)
-
During transport and storage: -20°C to +55°C (-4°F to 131°F)
Relative humidity:
-
Up to 50% at 40°C (104°F)
-
Up to 90% at 20°C (68°F)
Ambient air: free of dust, acids, corrosive gases or substances, etc.
Altitude above sea level: up to 2000 m (6561 ft. 8.16 in.)
Obligations of the
Operating Com-
pany
The operating company must only allow persons to work with the device if they
-
Are familiar with the basic occupational safety and accident prevention regulations
and are trained in handling the device
-
Have read and understood these Operating Instructions, especially the section "Safe-
ty Rules," and have confirmed this with their signature
-
Are trained according to the requirements for the work results
The safety-conscious work of the personnel must be checked regularly.
