Fronius Robacta Reamer X-Line J, Operating Instructions Manual

Page: 57 / 76

Service, maintenance and disposal
General The cleaning device does not usually require maintenance. To ensure the cleaning
device remains operational over time, there are a number of care and maintenance tasks
that need to be carried out, however:
Before every
start-up - Check the fill level in the parting agent container and top up the parting agent con-
tainer if necessary
- Check the fill level in the parting agent collecting container and drain the parting
agent collecting container if necessary
- Check for wear of the cleaning cutter and replace the cleaning cutter if necessary
- Drain the cleaning device's collecting container
- Drain the wire cutter's collecting container, if present
- In general, you should visually inspect the cleaning device and ensure that any dam-
age is repaired immediately (before commissioning)
Daily
CAUTION!
Danger due to cleaning agents containing solvents.
This can result in damage to property.
▶
Only clean the cleaning device with cleaning products that are free of solvents.
1
Remove deposited parting agent and contamination from the device
Weekly
NOTE!
Only clean the parting agent container with cleaning products that are free of
solvents.
- Check the parting agent container and parting agent collecting container for contam-
ination and clean if necessary
- Blow out the intake filter in the parting agent container from the inside out with com-
pressed air using the intake hose (“Starting Up the Parting Agent Atomizer” chapter)
Every 6 months
1
Open the device and check the pneumatic valves to ensure
-
No leaks
- All screws are screwed tightly in place
- All screw joints are fixed firmly in place on the pneumatic valves
Whenever
required Open the device and
1
Blast the inside of the device clean with dry and reduced compressed air
2
Lightly oil the guides on the lifting device's lifting cylinder
3
Restore the original state of the device
57
EN-US