Fronius Robacta Reamer V Twin, Operating Instructions Manual

Page: 74 / 92

Adjust the swivel
mechanism stop
angle - Banking screw (4) adjusts the left stop angle
- Banking screw (5) adjusts the right stop angle
(2)
(3)
(5)
(4)
1
Undo nut (2) or (3) depending on
the stop angle to be adjusted
2
Depending on the stop angle to be
adjusted, undo banking screw (4)
or (5) until the cleaning motor can
be moved to the highest position
where it is not in contact with the
welding torch parts
3
Manually tilt the cleaning motor to the side to be adjusted and move to the
highest position
4
Adjust the respective banking screw so that the cleaning cutter cannot col-
lide with a contact tip or a gas nozzle
5
Return the cleaning motor to the lowest position
6
Secure the banking screw using the nut (2) or (3) undone previously
2-3mm
0.08-0.12in
0,5-1mm
0.02-0.004in
7
Manually move the cleaning motor
to the highest position
8
Manually tilt the cleaning motor to
the left and right
- the cleaning cutter must not
collide with the contact tips or
gas nozzle
9
If the cleaning cutter touches
welding torch components, adjust
the stop angle again
74