Fronius RCU 5000i, Operating Instructions & Spare Parts

Page: 121 / 248

121
EN
Wirefeed speed
The guideline value for the wire feed speed [m/min] is normally determined by trial and er-
ror or by performing a test weld.
Accepting volt-
age and current
guideline values Voltage and current guideline values are accepted by the remote control unit directly from
the test weld:
Voltage and current guideline values during test weld,
continuous black selection bar
Set welding voltage and welding cur-
rent at the power source
Perform test weld
– During the welding process, the
present values for welding voltage
and welding current appear as ac-
tual values on the remote control
unit. The values cannot be altered
during the welding process; the
selection bar appears completely
black.
At the end of welding, the last active
hold values for welding voltage and
welding current are accepted as volta-
ge and current guideline values. Volta-
ge and current guideline values can be
kept or reset.
1
2
3