Fronius KD 7000, Operating Instructions Manual

Page: 25 / 60

25
EN
(3) Wire retraction length adjuster
to set the length of wire retracted at the end of welding
Scale from 0 to 10:
-
0 .........................1 mm
- 10 .......................50 mm
(4) Connection for external wire drive (14-pin plastic CPC socket)
to control an external wire drive (VR 1530 KD/Robacta Drive KD)
(5) Torch control connection
to connect the control plug for the TIG-KD manual torch
(6) Welding torch central connector (only in combination with internal wirespool
holder or integrated 4 roller drive)
for the wirefeed/Robacta Drive KD/TIG-KD manual torch hosepack
(7) Mains fuse protection 2 A
(8) Mains switch
lights up when the KD 7000 is switched on
(9) LocalNet connection socket
standardised connection socket for the system defaults
(10) KD control interface (37-pin plastic CPC socket)
for external control of the KD 7000 using analogue and digital signals
(11) Mains cable
(12) External welding wire feed
can be used for external wirefeeding
(13) Wirespool holder with deceleration device
accepts standardised welding wirespools up to max. 16 kg (with internal wirespool
holder)
(14) 4 roller drive (only with internal wire drive)
(15) Wire threading/feeding out button
to thread and feed the wire out of the hosepack
-
Wire threading: Push button down and hold
- Feed out: Push button up and hold
The feeder inching speed adjuster is used to set the wire threading and feed-out
speed
(16) Feeder inching speed adjuster
to display and set the wire threading and feed-out speed
(0.2 m/min up to maximum wire speed)
Item Designation