Fromm
71
INSTALLATION
71
To install the ramp on a different side or to move it, proceed as follows:
A)
Remove the casings
(1)
and
(2)
.
B) Disconnect the connector
(6)
from the sensor
(7)
.
C)
Remove the screws
(5)
and detach the ramp
(3)
from the base
(4)
.
D)
Once the side where the ramp
(3)
is to be installed is determined,
remove the casing
(8)
by removing the screws
(9)
.
INFORMATION
Based on the rotation direction of the plate, the casings (8) contain
the connector cable (6). If present, the cable must be removed
before the casing, sliding it backward.
E)
Re-install the ramp
(3)
and the casing
(8)
in the new positions,
tighten and lock the screws
(5)
and
(9)
.
F) Using the path provided by the casings
(8)
, run the connector
(6)
back to the sensor
(7)
and connect them.
G) Replace the casings
(1)
and
(2)
.
3
5
2
8
9
9
1
4
8
7
6
5
»
Picture 47
Summary of Contents for FS380
