9
P322mane.fm
Removing the empty battery
If the red LED starts lighting while a tensioning or welding procedure, the capacity of the battery is exhausted.
All electric functions of the tool are blocked.
The seal efficiency is insufficient.
Warning! Straps with insufficient seal strength must be removed from the package!
The battery must be recharged.
Push the unlatching push buttons at both sides of the battery.
Push the battery out of the tool in the opposite direction of insertion.
When removing the battery the LED lights shortly red.
5.2
Adjustments
5.2.1 Preselecting of strap tension and tensioning speed
Do not adjust the tensioning force too high.
If the tensioning force is higher than the tensioning strength of the strap,
the strap will tear while the tensioning.
Tensioning force and tensioning speed can be
preselected with the right adjusting knob.
Turning clockwise increases;
turning counterclockwise decreases the tensioning
force and the tensioning speed resp.
The tensioning force on the minimum setting is
400 N (90 lbs) and it is increased on the maximum
setting to 2000 N (450 lbs).
The tensioning speed on the minimum setting is
250 mm/s (9.8 inch/sec), it is increased on the
middle setting to 340 mm/s (13.4 inch/sec) and
remains on this value till the maximum setting.
5.2.2 Adjusting the welding time
Depending on the size and quality of the strap,
different welding times are required.
The welding time can be adjusted at the left
adjusting knob.
Turning clockwise increases,
turning counterclockwise decreases the welding
time.
5.3
Feeding the strap around the
package
The strapping is fed around the package as
illustrated.
Warning! The plastic strap which will be
welded must be free from oil, grease and
other dirt.
Dirty plastic straps can't be welded
correct!
Adjusting knob welding time
Adjusting knob tensioning force /
tensioning speed
