1
SPECIFICATIONS
Model
Heater Core
CFM
Warm up time
Fobbles F4
1400 Watts
10,000 cfm (Continuous)
6 Min
IMPORTANT
DO NOT PUT BUBBLE FLUID IN THE REAR FOG FLUID RESEVOIR BOTTLE. THIS WILL DAMAGE THE HEATER
CORE AND VOID THE WARRANTY OF THE MACHINE
The manufacturer will not accept liability for any resulting damages caused by the non‐observance of this
manual or any unauthorized modification to the equipment.
Do not open the equipment and do not modify the equipment.
Do not expose to flammable sources or gases.
Always disconnect the power from equipment when not in use or before cleaning! Only handle the
power‐cable by the plug. Never pull out the plug by pulling the power‐cable.
Make sure that the available voltage is 120VAC.
Make sure that the power‐cable is never crimped or damaged. Check the equipment and the power‐cable
periodically.
If the equipment is dropped or damaged, disconnect the mains power supply immediately. Have a
qualified engineer inspect the equipment before operating again.
If the equipment has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation might damage the equipment. Leave the equipment
switched off until it has reached room temperature.
Only use fuses of same type and rating.
Repairs, servicing and power connection must only be carried out by a qualified technician.
THIS UNIT CONTAINS NO USER SERVICEABLE PARTS.
SETUP
Open the box to verify product integrity. If the unit’s housing or cable is damaged, do not plug it in and do
not attempt to use it until after contacting your dealer for assistance.
Place fog bubble machine on a level flat surface, remove fog liquid reservoir cap toward rear of the machine.
Fill fog fluid reservoir with Froggys Fog Brand Fog Fluid. Lower quality fluid can damage the unit. Recap
tank.
Fill bubble reservoir at the front with a high‐quality bubble fluid, such as Froggys Fog Max Bubbles. Lesser
quality bubble fluids cannot withstand the increased pressure of hot fog and will burst prematurely. The
bubble solution can become diluted with fog moisture over time and occasionally will need to be drained
and refilled fresh during use.
Fobbles F4
-
User Manual
