Page 10
PULVERISETTE 7
3
Installation
3.1 Unpacking
Open the bandages with which the hood is fastened on the transport pallet.
The hood is a wooden box placed over the transport pallet.
Lift the hood off the transport pallet.
The cellular parts can be removed now or during the installation. To ease this
removal you can break the performated segments.
Check
that
the
items
supplied
correspond
to
your
order.
Grinding bowls of hardened steel may exhibit surface indentations caused by
the manufacturing process. These do not influence the grinding or the grind-
ing
result
and
generally
disappear
after
the
first
grinding.
When present, these surface indentations lie within the permissible manufac-
turing tolerance ranges. Accordingly, complaints regarding such grinding
bowls cannot be accepted.
Please store the transport packing carefully to use it again in case of an
eventual return of the instrument. Fritsch GmbH does not bear the risk of
damages depending on improper packings (non-Fritsch packings).
3.2 Transport
Transport the planetary micromill on the transport pallet with a
fork lift truck or a hand fork lift truck.
To carry the machine, grip it below the edge of the housing.
Carrying the machine will require at least two persons.
3.3 Erection
Lift the planetary micromill off the transport pallet.
Lifting the machine down will require at least two persons.
If the cellular parts have not yet been removed, this can be done now. See
section 3.1 Unpacking.
Place the planetary micromill on a level, stable surface, indoors. It is not
necessary to fasten the planetary micromill on the erection site.
The planetary micromill can also be mounted on a sturdy table.
It is inadvisable to operate the planetary micromill while it is stand-
ing on the transport pallet.
Ensure that there is good access to the planetary micromill. There
must be enough space to reach the main switch.
Do not block the exit of air from the ventilator louver at the side. There
is a danger of overheating if the louver is blocked.