/ / FSP SERIES / / /
34
11.4.3 Moving With Crane
Falling Parts
Death from crushing, pinching of extremities, material damage.
Only use suitable means of conveyance and hoists that are
designed for the total weight of the pump.
Information on the pump weight can be found on the
pump's rating plate as well as in the
"Order-Related Docu-
ments"
in the attached documents.
Do not leave the pump in a raised position for longer than
necessary.
Ensure that the area below the pump is clear of people.
Swinging Parts
Crushing and serious injuries.
Start and stop the crane with pump smoothly.
Ensure that the danger zone of the pump is clear of people.
Auxiliary Equipment
– Hoists: round slings tested in accordance with DIN EN 1492-1
and 1492-2
– Eyebolt and suitable eyebolt lifting devices
Fig. 53
Moving with crane
Preparation
Remove load-securing devices.
To move the KF pump with the round sling:
Procedure
1. Wrap the round sling twice around the lantern neck (see
Fig. 53 "Moving with crane" page 34
2. Guide the other end of the round sling to the crane hook and
hook on.
3. Position the center of gravity to ensure that the pump is lift-
ed horizontally.
4. Lift the pump.
To move the L pump with the round sling:
Procedure
1. Wrap the round sling twice around the back end of the bear-
ing block (see
Fig. 53 "Moving with crane" page 34
).
2. Lay the other end of the round sling around the suction port
on the pump cover. Do not lay the round sling over any
sharp edges or corners.
3. Guide both loops to the crane hook and rotate by 180° to en-
sure that the belt will not slip on the hook.
4. Position the center of gravity to ensure that the pump is lift-
ed horizontally.
5. Lift the pump.
11.5 Installation Location
Please see the operator's manual
Chapter 6.2, "Installation Loca-
for the basic installation location requirements.
11.6 Pump Installation
11.6.1 Model KF
Prerequisites (Customer-Side)
– Suitable motor
Incorrectly Designed Motor
Destruction of pump.
Only use motors that have been adapted to the pump char-
acteristic curves. If you have any questions, please contact
Fristam
.
Procedure
1. Insert the key into the slot on the motor.
2. Slide the motor shaft into the compact bearing support.
3. Screw the motor to the compact bearing support. Tighten
screws crosswise.
11.6.2 Model L
Prerequisites (Customer-Side)
– Suitable gear motor
– Adequately sized coupling
– Common installation surface for gear motor and pump so
that pump shaft can be aligned with gear motor shaft