2
30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with an Electric Oven and a Gas Cooktop)
V
Y
Z
W
NOTE:
1. Do not pinch the power supply cord or the
flexible gas conduit between the range and
the wall.
2. Do not seal the range to the side cabinets.
3. 24" (61 cm) minimum clearance between the
cooktop and the bottom of the cabinet when
the bottom of wood or metal cabinet is
protected by not less than ¼" (0.64 cm) flame
retardant millboard covered with not less
than No. 28 MSG sheet metal, 0.015"(0.4
mm) stainless steel, 0.024"(0.6 mm)
aluminum, or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance when the
cabinet is unprotected.
4. For cutouts below 22 7/8"(58.1 cm),
appliance will slightly show out of the
cabinet.
5. Allow at least 19 ¼" (48.9 cm) clearance for
door depth when it is open.
35 5/8" (90.5 cm) -
36 5/8" (93 cm)
30" (76,2 cm)
28 5/16" (71,9 cm)
30±1/16"
(76,2±0,15 cm)
21 3/4" (55,2 cm) Min.
22 1/8" (56,2 cm) Max
24" (61 cm) Min. with
backguard
36 5/8" (93 cm) Max.
35 5/8" (90.5 cm) Min.
A
. HEIGHT
B
.
WIDTH
D
.
DEPTH TO
FRONT OF RANGE
E
.
CUTOUT WIDTH ***
(Countertop and
Cabinet)
F
.
CUTOUT
DEPTH
G
.
HEIGHT
OF COUNTERTOP
31½" (80 cm)
C.
COOKTOP
WIDTH
21¾”
(55.25 cm)
D
C
A
B
Door
Open
Side Panel
1 1/8"
(2.86 cm)
FRONT OF
CABINET
F
Ref.
22 7/8"(58.1 cm) min.
23 1/4"(59.05 cm) max.
(see Note 4)
A =
must be
higher than
about 1/16" than
the greatest
value between
V,W,Y,Z.
Illustration 1
Illustration 2
To avoid breakage: Do NOT handle or manipulate the unit by the cooktop glass.
1 Before installing the unit, measure the height
V, W, Y, Z
of the cabinet (see illustration 2).
2 Level the unit to have the proper height
A
(see illustration 1) by the
four
leveling legs.
3 Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center of the
cabinet cut-out. Remove the plastic extrusion on each side of the glass cooktop (some models).
4 It is imperative that the metal flange under each sides of the cooktop are over the cabinet
countertop. The glass cooktop should not touch directly the countertop. Level the unit if needed.
5 After the installation, MAKE SURE that the unit is supported by the leveling legs NOT by the
cooktop glass itself.
