29
CARE & CLEANING
•
Chrome control panel
(some models)
•
Decorative trim
(some models)
Surface type
Recommendation
•
Porcelain enamel broiler pan and broiler
pan insert
(if equipped)
•
Door liner & body parts
Use hot, soapy water and a cloth. Dry with a clean cloth.
For general cleaning, use hot, soapy water and a cloth. For more
difficult soils and built-up grease, apply a liquid detergent directly
onto the soil. Leave on soil for 30 to 60 minutes. Rinse with a
damp cloth and dry.
Do not
use abrasive cleaners on any of these
materials; they can scratch. To remove control knobs, turn to the
OFF position; grasp firmly and pull straight off the shaft. To replace
knobs after cleaning, line up the flat sides of both the knob and the
shaft; then push the knob into place.
•
Painted and plastic control knobs
•
Painted body parts
•
Painted decorative trim
•
Aluminum (trim pieces) & vinyl
Gentle scouring with a soapy scouring pad will remove most spots.
Rinse with a 1:1 solution of clear water and ammonia. If necessary,
cover difficult spots with an ammonia-soaked paper towel for 30
to 40 minutes. Rinse with clean water and a damp cloth, and then
scrub with a soap-filled scouring pad. Rinse and wipe dry with
a clean cloth. Remove all cleaners or the porcelain may become
damaged during future heating.
Do not
use spray oven cleaners on
the cooktop.
•
Easy Care™ Stainless
Steel
(some models)
•
Oven racks
•
Oven door
Oven racks must be removed from oven before starting
self-clean cycle.
Clean by using a mild, abrasive cleaner following
manufacturer’s instructions. Rinse with clean water and dry.
Cleaning recommendation table
See “Cooktop Cleaning and Maintenance” later in the
Care &
Cleaning
section.
•
Ceramic cooktop
Use soap & water to thoroughly clean the top, sides and front of the
oven door. Rinse well. You may use a glass cleaner on the outside
glass of the oven door.
Do not
immerse the door in water.
Do not
spray or allow water or the glass cleaner to enter the door
vents.
Do not use oven cleaners, cleaning powders or any harsh
abrasive cleaning materials on the outside of the oven door.
Do
not
clean the oven door gasket. On self-cleaning models the oven
door gasket is made of a woven material which is essential for a
good seal. Care should be taken not to rub, damage or remove this
gasket.
Before cleaning the control panel, turn all controls to OFF and
remove the control knobs. To remove, pull each knob straight off
the shaft. Clean using hot, soapy water and a dishcloth. Rinse with a
clean water using a dishcloth. Be sure to squeeze excess water from
the cloth before wiping the panel; especially when wiping around the
controls. Excess water in or around the controls may cause damage
to the appliance.To replace knobs after cleaning, line up the flat
sides of both the knob and the shaft; then push the knob into place.
If your range finish is
Easy Care™ Stainless Steel
(some models),
clean the stainless with warm soapy water using a clean sponge or
cloth. Rinse with clean water and dry with a soft clean cloth.
DO
NOT
use
ANY
store bought cleaners like Stainless Steel cleaners
or any other types of cleaners containing any abrasive, chlorides,
chlorines or ammonia. It is recommended to use mild dish soap and
water or a 50/50 solution of water and vinegar.
