23
Lower Spray Arm, Spray Arm Support
& Filter
See Figure 43
1. Remove lower rack
2. Lower spray arm clips onto the lower spray arm
support lift spray arm off support
Spray arm support & Filter
1. Turn support clockwise 90° lift support from
sump.
2. Filter is now free to lift out
Spray arm support
Lift out basket
Filter
HEATING ELEMENT
1. Disconnect the dishwasher from electrical supply
2. To remove element disconnect wiring and
remove two element mounting nuts. See Figure
45
3. Lift terminal ends from tub.
4. Raise locking hook on mounting brackets to slide
element from brackets. See Figure 44
Heater
FLOAT SWITCH AND MOUNT BRACKET
1. Disconnect the dishwasher from electrical supply
2. For ease of service, remove outer door panel
and the kick plate, remover wires to float switch.
3. Unscrew Phillips screw holding assembly to tub,
there is a hole provided in the actuator lever to
access screw. Screw will remain in assembly
once removed.
4. When installing Switch and bracket onto tub
make sure mount stays tight to tub. See Figure
46
Remove float by lifting up out of tube molded in
bottom of tub.
WATER VALVE
1. Disconnect the dishwasher from electrical
supply
2. Turn water off to dishwasher before replac-
ing valve
3. Gain access to valve remove wiring, water
line, and fitting from valve.
4. Water valve is secured with two screw
s.
See
Figure 47
Testing water valve and float switch is best
preformed by using the Water Service Test see
section on testing the control system to start this
test.
Mounting
screws
Figure 43
Figure 44
Figure 45
Figure 46
Figure 47
