8
INSTALLATION
Door Opening
Position your unit to allow easy access to
a counter or table when removing food.
For the best use of drawers and freezer
baskets, position the appliance where
both doors can fully open.
Guidelines for final positioning
of your unit:
• Rest all 4 corners of the cabinet
firmly on the floor.
• Level the cabinet at the front and rear.
• Tilt the sides
¼
" (6 mm) from front
to back (to ensure the doors close
and seal properly).
• Align the doors with each other
and level.
Meet all of these conditions by
raising or lowering the adjust-
able front rollers.
To level the cabinet using the front rollers
:
1. Open both doors and remove
in the
INSTALLATION
section).
2. Close the doors and use a wrench
to raise (clockwise) or lower
(counterclockwise) the front rollers.
3. Ensure both doors are bind-free
with their seals touching the cabinet
on all 4 sides.
NOTE
T
he doors are designed to shut by
themselves within a 20 degree opening.
Toe Grille Installation and Removal
To install toe grille
1. Open both doors. Slide the left and
right sides of the toe grille over the
lower hinges of the appliance.
2. While pushing the toe grille firmly
against cabinet, fasten the bottom
clips of toe grille to the cabinet.
3. Fasten the top clips to the cabinet.
4. Close the doors. Fasten the right
and left side clips into the groove of
the bottom hinge.
To remove the toe grille
1. With both doors closed, unfasten
the right and left side clips of toe
grille from the bottom hinge groove.
2. Open both doors. Press firmly on the
top of the toe grille until the top of
the toe grille pops off.
3. Pull the toe grille outward toward
your body and off of the lower hinges.
1
2
3
2
3
1
4
4
Installing Toe Grille
1
2
3 2
3
1
Removing Toe Grille
