8
Operating Instructions
Operating Instructions
(continued)
CHECK FILTER FEATURE, YOU WILL SEE:
.
d
e
v
r
e
s
e
r
s
t
h
g
ir
l
l
A
.
c
n
I
,
s
t
c
u
d
o
r
P
e
m
o
H
x
u
l
o
r
t
c
e
l
E
9
0
0
2
DO THIS:
PRESS FILTER
RESET BUTTON
TIMER: DELAY STOP / START FEATURE
YOU WILL SEE HOW MUCH TIME IS CHOSEN:
FIRST
DO THIS:
PRESS
TIMER BUTTON
THEN
DO THIS:
PRESS
UP/DOWN BUTTONS
Note: This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation. The LED
(light) will illuminate after 250 hours of fan operation. To reset
after cleaning the filter, press the "Filter Reset" button and
the light will go off.
Note: For Delay Stop, the unit must be in the On position
Note: For Delay Start, the unit must be in the Off position.
First, Press TIMER button, then adjust timer setting, tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay
timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time
remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool,
eco, or Fan Only was the last mode selected) . The temperature maintained will be the same as previously set. To change
the set temperature, press "mode" then Up or Down arrows until the desired temperature is indicated on the display. After 5
seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the
unit timer or on/off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the
unit either starts or stops. Once that happens the above steps have to be repeated again.
DO THIS:
PRESS MODE
BUTTON
SELECT HEAT
HEATING FEATURE(on some models)
：
YOU WILL SEE:
Note: This feature can be used with any combination of FAN
Speeds (Low speed only on 115V models), Timer, or Sleep Modes.
When in the "Heat" mode,the fan will run continuously while heat
is needed. The temperature will automatically be maintained
anywhere between 55 °F(13 °C) and 80 °F(27 °C). When the
room set temperature is satisfied, the fan will cycle off and on
to circulate and sample the room air.
