4
2009 Electrolux Home Products, Inc.
All rights reserved.
Allow the unit to reach room temperature before operating.
To begin operating the dehumidifier, follow these steps:
1. Plug the power cord into a properly grounded 115 volt AC outlet. Note the POWER indicators will illuminate.
2. To turn the unit on rotate the knob until it points to the CONTINUOUS setting. It is recommended you leave the
unit running in the CONTINUOUS setting for the first three or four days until any sweating and dampness odors
have ceased.
3. After a few days when the Relative Humidity has declined, rotate the HUMIDITY knob to a desired point on the
dial so the room is kept at a comfortable concentration. The unit will cycle on and off keeping the desired level
of comfort.
Operating Instructions
Operating Instructions
Unit must be upright for one hour prior to operating.
NOTE:
N
If the "BUCKET FULL" light is on, remove the bucket and re-install to reset the float switch.
If the "POWER" light blinks every 3 seconds, check the following operating conditions. Outlet voltage should
be 115V±10% and the surrounding temperature should be with in the range of 41 °F to 96 °F. Unplug the unit
and plug it in again under normal operating conditions. If the "POWER" light blinks again, contact your Authorized
Frigidaire Service Center.
NOTE:
N
If the "POWER" light blinks every 10 seconds, a sensor has failed. Contact your Authorized Frigidaire Service Center.
