23
CLEANING AND CARE
EXTERIOR
The outside surface is precoated steel and plastic. Clean
the outside with mild soap and water; rinse and dry with
a soft cloth. Do not use any type of household or abrasive
cleaner.
DOOR
Wipe the window on both sides with a soft cloth to remove
any spills or spatters. Metal parts will be easier to maintain
if wiped frequently with a soft cloth. Avoid the use of spray
and other harsh cleaners as they may stain, streak or dull
the door surface.
Your microwave oven(some models) may have a Stainless
Steel finish or coating. Clean the stainless with warm
soapy water using a clean sponge or cloth. Rinse with clean
water and dry with a soft clean cloth. DO NOT use ANY
store bought cleaners like Stainless Steel cleaners or any
other types of cleaners containing any abrasive, chlorides,
chlorines or ammonia. It is recommended to use mild dish
soap and water or a 50/50 solution of water and vinegar.
TOUCH CONTROL PANEL
Care should be taken in cleaning the touch control panel.
If the control panel becomes soiled, open the microwave
oven door before cleaning. Wipe the panel with a cloth
dampened slightly with water only. Dry with a soft cloth.
Do not scrub or use any sort of chemical cleaners. Close
door and touch
INTERIOR
OR HARSH CLEANERS OR SCOURING PADS. For heavier
WAVEGUIDE COVER
The waveguide cover is located on the right side in
the
microwave oven cavity. It is made from mica so
requires
special care. Keep the waveguide cover clean
to assure good microwave oven performance. Carefully
wipe with a damp cloth any food spatters from the surface
of the cover immediately after they occur. Built-up splashes
may
overheat and cause smoke or possibly catch fire.
DO NOT REMOVE THE WAVEGUIDE COVER.
ODOR REMOVAL
Occasionally, a cooking odor may remain in the microwave
oven. To remove, combine 1 cup water, grated peel and
juice of 1 lemon in a 2-cup glass measuring cup.
Boil for several minutes using 100% power.
Allow to set in microwave oven until cool. Wipe interior with
a soft cloth.
TURNTABLE/TURNTABLE SUPPORT
The turntable and turntable support can be removed for
easy cleaning. Wash them in mild, sudsy water; for stubborn
stains use a mild cleanser and non-abrasive scouring
excess water or spills should be wiped up
immediately.
Disconnect the power cord or leave the door open to deactivate the oven
during cleaning. Disconnect the power cord before replacing filters and lights.
sponge. They are also dishwasher-proof. Use upper
wirerack of dishwasher. The turntable motor shaft is not
sealed, so
soapy water, rinsed and dried.
interior surfaces
soil, use baking soda or a mild soap; rinse thoroughly with
Cleaning is easy because little heat is generated to the
. To clean the interior surfaces, wipe with
a soft cloth and warm water. DO NOT USE ABRASIVE
hot water. The round wire rack and shelf can be cleaned
with hot
STOP/CLEAR
EASY CARE™
/
STAINLESS STEEL
(SOME MODELS)
STAINLESS STEEL
/
STEEL
SMUDGE PROOF™ STAINLESS
_
BLACK
