134682200 0512
FUNCTION TEST SEQUENCE
1. Press and hold
Select
and
Cancel
buttons simultaneously for 6 seconds to reset the control. The buzzer will sound
1 time and “
rES
” will be shown briefly in the display.
2. Immediately after, rotate cycle selector knob 5 turns counter-clockwise to the second position from the bottom.
Press and hold the
Options
and
Cancel
buttons simultaneously for 2 seconds. The control will enter test mode,
the buzzer will sound 3 times and all LED’s will rapidly flash.
After entering the test mode, the cycle selector knob can now be rotated to select the following tests:
Rotate the cycle selector knob clockwise from the starting position:
0 turns:
All LED’s will flash.
1 turn:
Drive motor runs; heat source is on.
Drying
LED is lit. “
H
” and the control thermistor reading will toggle
back and forth in the display.
2 turns:
Drive motor runs; heat source is off.
Cool Down
LED is lit and “
AF
” (Air Fluff) is displayed.
3 turns:
Drive motor runs; heat source is off.
Drying
and
Cool Down
LED’s are lit and numbers appear in the
display showing moisture sensor readings. Opening the door (press in on door switch plunger) and placing
a finger on the both moisture sense bars at the same time will make the numbers decrease. In controls that
do not have a digit display, the
More Dry
LED should be ON. Opening the door (press in on door switch
plunger) and placing a finger on the both moisture sense bars at the same time will make the
Damp
LED
come on.
4 turns:
Drive motor runs; heat source is off.
Key test:
a. When the
Temperature
key is pressed, all the temperature LED’s should light.
b. When the
Dryness
key is pressed, all the dryness level LED’s should light.
c. When the
Options
or
Select
key is pressed, all the Option LED’s should light.
d. When the
Start/Pause
key is pressed, all the cycle status LED’s should light.
e. When the
Cancel
key is pressed, all the cycle status LED’s should light.
5 turns:
Drive motor runs; heat source is off.
Cool Down
LED is lit. Control thermistor reading is displayed.
6 turns:
Drive motor runs; heat source is on.
Drying
LED is lit. Control thermistor reading is displayed.
7-11 turns:
All LED’s will flash
To
EXIT
test mode, press and hold the
Select
and
Cancel
buttons simultaneously for 6 seconds or disconnect power
from dryer. Dryer will be reset for regular operation.