Frigelux RF 240A+, Instruction Manual

Page: 25 / 30

If really want to stop using the refrigerator it for a long period of time, please switch the unit off, and follow the above information to clean
and dry the unit. Thereafter keep it in the dry and clean place. Remember to leave the door slightly open to prevent the door seal form
sticking to the cabinet
Troubleshooting guide
1. Normal operating
The points set out below sre of no concern and indicates that the refrigerator is operating normally and should be of no concern.
The sound of running water indicates that the compressor is working correctly.
A “pengpeng” sound, indicates a sudden change in temperature. This is a normal change in the stresses of the materials used in the
manufacture of the refrigerator
Compressor heating up - When underworked - the highest temperature is 90
When the left and right side of the refrigerator heats up and when underworked, the two sides can reach an average of 55
The outer panels of refrigerator shows condensation as a result of excessive humidity in the air –please dry it off.
2. Troubleshooting
Please check the following prior to requesting a call for service
The refrigerator stops working
– Check that the unit is plugged in to the wall and that the plug is switched on.
Compressor not working - The thermostat is set too high.
The door can’t be closed . - The surrounding temperature is too high or the unit is in direct sunlight.
Unit is running yet not getting cold – The unit is overloaded affecting the cold air flow
- Hot food has been placed in the refrigerator.
- The door has not been closed properly
- The door has been opened and closed too many times in a short period
- The refrigerator is near the heater
- The thermostat position is too low