Chapter 4
Charging
4.1 Charging
Of all the areas regarding the Robomow, proper charging of the Power Pack is second only to safety in
importance. Failure to follow the charging guidelines will result in poor performance and a short Power
Pack life. After the completion of any daily cutting session it is very important to bring the Robomow to its
storage area and plug it into the
Power Supply
as soon as possible, preferably within 6 hours from the time it
stopped.
The standard
Power Supply
, Figure 4.1 is actually an indoor power supply, where the voltage output is DC
and the current flowing to the Power Pack for re-charging is regulated inside the mower. The charging
system and Power Pack are designed such that they can remain plugged in at all times of non-use without
concern to over charging, over heating or damaging the Power Pack. In fact, it is the preferred way to
maintain your Power Pack, always keep it plugged into the Power Supply between uses. The power supply
will re-charge the Power Pack from the ‘Recharge Battery’ level in approximately 24 hours, depending on
conditions. There is a fast charger available as an accessory. See the accessories available for your
Robomow in Chapter 9.
4.2 Charging Using the Standard Indoor Power Supply Connected to the Charging Socket
Connect the Indoor Power Supply
to a regular household receptacle, 120 Volts AC (models outside the US
utilize 230 volts mains power) and the output lead of the Power Supply, Figure 4.2, into the charging
socket, located under the Manual Controller holder, Figure 4.3, and the charging process will begin. Lightly
pivot the Manual Controller down, allowing it to rest gently on the charging cord. DO NOT attempt to force
the Manual Controller all the way to the flush position. The Robomow Power Supply
is designed for indoor
dry use only. Do not charge the Robomow where wet contact is likely.
Indoors Power Supply
120 volt shown
Figure 4.1
Power Supply plug
o
utput lead
Figure 4.2
!
Shock hazard. Injury or electrocution can occur. The Robomow
Power Supply is designed for indoor use in dry locations only.
Never use the Power Supply or charge the Robomow in areas where
extreme dampness or wet contact is likely. Never use a Power
Supply when the leads are damaged. Use only the recommended
Power Supply with your Robomow.
WARNING!
Figure 4.3
Power Supply
connector socket
34
Summary of Contents for RL550
Page 1: ...Operating Safety Manual RL350 550 850 www friendlyrobotics com DOC0099A ...
Page 2: ......
Page 3: ......
