Figure 3: WY/WE heat-cool model remote control
Additional RC1 wireless remote controls can be purchased from your Friedrich dealer.
Figure 4: WS Models Only
Additional RC1 wireless remote controls can be purchased from your Friedrich dealer.
Using the remote control
To start unit
1
POWER -
Press the
Power
button once. The unit will automatically
start in the mode and fan speed it was last left on.
To set mode of operation
2
COOL -
Press the
Cool
button to automatically switch the operat-
ing mode to COOL.
3
FAN ONLY -
Press the
Fan Only
button if you want to run the
fan only.
4
HEAT (WY/WE models only) -
Press the
Heat
button to
automatically switch the operating mode to HEAT.
5
MoneySaver
®
-
Press the
Money Saver
®
button to activate
the MoneySaver
®
feature. This feature cycles the fan with the
compressor so that the fan does not run all the time.
To adjust temperature
6
WARMER -
Press the
Warmer
button to raise the temperature sett
tt
ing.
ing.
7
COOLER -
Press the
Cooler
button to lower the temperature se
To adjust fan speed
8
FAN SPEED
- Press the
Fan Speed
button to see the current
setting. Press again to change the fan speed. F1 is the lowest
setting (SLEEP / LOW), F2 is MEDIUM, F3 is HIGH, and SF is
the SMART FAN setting.
To set the hour clock
9
SET HOUR CLOCK -
Press the
Set Hr
.
button once to see the
current clock setting. Continue pressing the button until you
arrive at the current time (Hour only). Minutes are not shown on
the display. Make sure that the A.M. / P.M. setting is correct.
To set the timer
NOTE: You can set the START and STOP times a minimum of one
hour apart, and a maximum of 23 hours apart.
10
TIMER START
- Press
Start
to view the current start time for cool-
ing. Continue pressing the START button until you arrive at the start
time you desire. The start time for cooling will then be set.
11
TIMER STOP
- Press the
Stop
button. Continue pressing the
STOP button until you arrive at the stop time you desire. The
stop time for cooling will then be set.
12
TIMER ON / OFF
- Press the
O n/Off
button (under
Timer
Operation
.r
e
m
it
e
h
t )
ff
o
th
gi
l(
et
a
vi
tc
a
e
d
r
o
)
n
o
th
gi
l(
et
a
vi
tc
a
ot
)
Once the on and off times have been selected, they will remain
in memory and cycle daily until changed.
NOTE:
If the unit is unplugged or the power is interrupted, the
Set Hr
.
function must be reset or the
Timer On/Off
function will not work.
11
Summary of Contents for WallMaster 2008
Page 58: ......
