6
920-036-05 (10-04)
STEP 9
CUT WINGBOARD PANELS –
Measure and cut the wingboard panels from the Masonite sup plied (Item #8) to fi t
the spaces between the side window channels and the sides of the cab i net.
(See Figure E.)
NOTE:
AFTER CUTTING THE PANELS, MAKE A TRIAL TEST TO SEE IF THEY FIT THE SPACE WITH ABOUT
1
⁄
8
"
CLEAR ANCE BEFORE GOING TO STEP 10.
STEP 10
ASSEMBLE THE CLIPS TO THE WINGBOARD PANELS –
Assemble the "J" type speed nuts (Item 9) and spring
steel clips (Item 10) to the edges of the cut wingboard panels (See Figure F.)
STEP 11
INSTALL THE SIDE WINGBOARD PANELS –
Be sure the cabinet has been secured to the win dow sill and that
the outside support brackets have been installed as shown in Figures C and D on Page 4. Raise the window sash and
install the right and left side wingboard panels. (See Figure G, Page 7.)
STEP 12
INSTALL THE WINDOW SEALING GASKETS –
Measure and cut the vinyl window seal gasket (grey color, Item
# 12) to fi t the width of the window, and install as shown in Figure H on Page 7. Pull the window sash down behind
the gasket. Measure and cut the dark foam window seal gasket (Item #13) and install it between the upper glass panel
and the top part of the lower sash. (See Figure H, Page 7).
NOTE:
FOR REASONS OF SECURITY AND SAFETY, THE CUSTOMER MUST PRO VIDE A MEANS
OF PRE VENT ING THE WINDOW FROM OPENING.
FIGURE E
MEASURE DISTANCE "B" TO INSIDE OF THE
CHANNEL ON EACH SIDE
CUT HERE AND DISCARD CENTER WASTE
MATERIAL.
WINGBOARD
SUBTRACT ⅛" FROM DIMENSION "B" AND
MEA SURE FROM THE EDGE OF THE WING-
BOARD (ITEM # 8), MARK, AND CUT WITH A
SAW
"J" TYPE SPEED NUT
(ITEM #9) 2 REQUIRED
SPRING STEEL CLIP
(ITEM #10) 2 RE QUIRED
CUT EDGE
SLIDE CLIP OVER CUT EDGE
OF WINGBOARD PANEL
CENTER THE HOLE IN THE
SPEED NUT OVER THE SLOT
IN THE WINGBOARD PANEL
CUT WINGBOARD PANEL
3"
3"
FIGURE F
Summary of Contents for QUIETMASTER Programmable SS10L10
Page 43: ...43 920 036 05 10 04...
