28
920-198-00
OPTIONAL:
The factory assembles the supply cord so that it exits the left
side of the unit at the bottom. At the consumer’s discretion,
the supply cord can be routed to exit the right side of the unit.
To do this, route the supply cord to the right side. Pull the
supply cord taunt through the loops (Refer to Cord Routing
Change, Figure 37) and route the cord down.
STEP 13.
To attach and prevent damage to the front grille align the cord
notch over the cord and center the fresh air lever, then align and
tighten the four (4) captive screws as indicated by the arrows in
Figure 28. Before closing the front panel, be sure the
fi
lter is
in place. Make sure curtains do not block the side air intakes.
STEP 14.
You are now ready to control the comfort level of the room.
Use Tool Provided
Please use the provided tool to attach the decorative front to the chassis.
Figure 28
FRR024
NOTE:
WHEN INSTALLING THE CHASSIS
SEAL GASKET; BEGIN AT EITHER BOTTOM
CORNER AND GO UP THE SIDE & ACROSS
THE TOP & DOWN THE OPPOSITE SIDE.
POWER CORD
CLIP
CHASSIS SEAL
GASKET (ITEM 14)
Figure 29
B
USE HAND TOOLS
DO NOT OVER TIGHTEN
LOCATION OF GRILLE
REMOVAL TOOL
FRR053
