Friedrich FSHSW09A1A, Installation And Operation Manual

Page: 18 / 40

8
Surge button
Under COOL or HEAT mode, press this button to activate / deactivate the Surge function.
Note: Not applicable for this unit.
Note:
● Outdoor temperature display is not available for some models. At that time, indoor
unit receives " " signal, while it displays indoor set temperature.
will change quickly if holding " " or " " button). Time setting range is 0.5~24hours.
Press this button again to confirm timer setting and the characters of HOUR ON
(OFF)will stop flashing.
If the characters are flashing but you haven’t press timer button,timer setting
status will be quit after 5s.If timer is confirmer, press this button again to cancel
timer.
● Under ON status, press this button to set timer OFF; Under OFF status, press
this button to set timer ON.
● Press this button once and the characters of HOUR ON (OFF) will flash to be
displayed. Meanwhile, press " " button or " " button to adjust timer setting (time
Press this button, you can see indoor set temperature, indoor ambient temperature
on indoor unit’s display. The setting on remote controller is selected circularly as below:
no display
Introduction for buttons on remote controller
13
▲
▲
▲
▲
7
Temp button
10
Timer button
Sleep button
6
Under Cool or Heat mode, press this button to turn on Sleep function. Press this
button again to cancel Sleep function. Under Fan
、
Dry and Auto modes, this
function is unavailable.
Swing button
5
Press this button to set up & down swing angle.
9
Hold ° button
Press this button to start Hold ° function and " " will be displayed on the remote
controller. After this function is set, the remote controller will send the detected
ambient temperature to the controller and the unit will automatically adjust the
indoor temperature according to the detected temperature. Press this button again
to close Hold ° function and " " will disappear. When Hold ° function is turned on,
the remote controller should be put within the area where indoor unit can receive the
signal sent by the remote controller.
11
Dry button
Press this button in COOL or DRY mode to turn on Dry function.
When this function is started up, indoor fan will still operate at low fan speed for a
while after turning off the unit by remote controller.