RETURN JACK:
This is where you plug the OUT of your Effect(s). Use a high quality shielded guitar cable.
SEND JACK:
This is where you plug the INPUT of your Effect(s). Use a high quality shielded guitar cable.
SPEAKER OUT JACKS (2):
Plug your speaker cabs in here. Make sure your amp ALWAYS has a speaker
load attached or severe damage will occur.
IMPEDANCE SELECTOR SWITCH:
Set to correct speaker load impedance that is connected to your amp.
LINE OUT JACK:
This is an output to send a line level signal. Eg: to feed another amp or FX unit, etc. This
is not speaker compensated so it is great to use as a direct source and to add speaker iR’s for recording,
etc.
LINE OUT LEVEL CONTROL:
This controls the level of the LINE OUT signal.
HT FUSE:
Only replace with 1 Amp( for 115v) or .5 Amp(for 230v) fuse. If this blows, don’t freak out too
much. It’s most likely a bad power tube. We recommend you carry a few spare fuses and a spare set of
tubes when gigging. If the fuse continues to blow after swapping out the tubes then call Support or send
your amp in for repair.
MAINS FUSE:
This fuse is in the compartment found below the AC receptacle. Replace with 3 amp
Slo-‐Blo (North American Voltage) or 1.5 amp Slo-‐Blo (Euro Voltage). This is located in the IEC Housing.
MAINS INPUT:
Plug the supplied IEC power cord here and into a 115v wall outlet to power the beast.
Summary of Contents for SMALLBOX
Page 1: ...INSTRUCTION MANUAL...
