Rittal enclosure cooling unit
3
1 Notes on documentation
EN
1
Notes on documentation
1.1
CE labelling
Rittal GmbH & Co. KG confirms the conformity of the
cooling unit with the European Union's Machinery Di-
rective 2006/42/EC and EMC Directive 2014/30/EC. A
corresponding declaration of conformity has been is-
sued. This can be found at the end of this document, or
on the Rittal homepage.
1.2
Storing the documents
The assembly and operating instructions as well as all
other applicable documents are an integral part of the
product. They must be issued to everyone who works
with the unit and must always be available and on hand
for operating and maintenance personnel.
1.3
Symbols used in these operating in-
structions
The following symbols are used in this documentation:
This symbol indicates an "action point" and shows that
you should perform an operation or procedure.
1.4
Other applicable documents
Assembly and operating instructions in paper and digital
format are available for the unit types described here.
We cannot accept any liability for damage associated
with failure to observe these instructions. Where applica-
ble, the instructions for any accessories used also apply.
2
Safety notes
Please observe the following general safety notes when
assembling and operating the unit:
– Assembly, installation and servicing may only be per-
formed by properly trained specialists.
– Do not obstruct the air inlet and air outlet of the cooling
unit inside and outside the enclosure (see sec-
tion 4.2.2 "Layout of the electronic components in the
enclosure").
– The heat loss of the components installed in the enclo-
sure must not exceed the specific useful cooling pow-
er of the cooling unit.
– The cooling unit must always be transported in a hori-
zontal position.
– Use only original spare parts and accessories.
– Do not make any changes to the cooling unit other
than those described in these instructions or associat-
ed instructions.
– Risk of burns! On cooling units with automatic con-
densate evaporation, the surface of the thermal ele-
ment will get very hot during operation, and will remain
so for some time afterwards.
– The mains connector of the cooling unit must only be
connected and disconnected with the system de-en-
ergised. Connect the protective device specified on
the rating plate.
3
Device description
Depending on the model chosen, your cooling unit may
vary in appearance from the illustrations contained in
these instructions. However, the functions are identical
in principle.
Danger!
A dangerous situation in which failure to
comply with the instructions will result in
death or severe injury.
Warning!
A dangerous situation which may cause
death or serious injury if the instructions
are not followed.
Caution!
A dangerous situation which may lead to
(minor) injuries if the instructions are not
followed.
Note:
Important notices and indication of situations
which may result in material damage.
Summary of Contents for Rittal 3273 Series
Page 31: ......
