5 Assembly and commissioning
8
We reserve the right to make technical modifications
Rittal Support rail cutter MC3
EN
5
Assembly and commissioning
You receive all required parts as well as detailed operating instructions.
On receiving the goods, check them for possible transport damage and the
delivery for completeness.
In the event of problems, contact the manufacturer or your vendor without
delay.
In any case, read the complete operating instructions as well as all supplied
documents before commissioning the unit.
Assembly
First screw-in the hand lever into the eccentric lever (fig. 3, item 1) and tight-
en.
Then push the labelled ruler on the shoulder of the base plate and fasten with
the M10x16 bolt and washer (fig. 3, item 5).
Now move the limit stop (fig. 3, item 3) on the ruler, as shown, and click the
individual metal foot (fig. 3, item 4) into the rear opening of the ruler.
The ruler should now be set to the exact dimension.
To do this, set the limit stop with the read-off edge (fig. 3, item 6), e.g. at
118 mm, and measure the distance between the stop flap (fig. 3, item 2) and
the shear plate with a steel scale.
Because the moveable shear plate is 18 mm thick, move the ruler so that a
distance of exactly 100 mm results between the shear plate and the stop
flap.
Tighten the M10x16 bolt (fig. 3, item 5) so that the ruler is positioned exactly.
Fig. 3:
Assembly sequence
