Fridgemaster MUR4996, User Manual

Page: 7 / 12

7
REVERSING THE DOOR SWING
Remove the top hinge bracket cover. You may need
to carefully lever it off with a flat bladed screwdriver. Lean the refrigerator back no more than 45º. Remove
the two adjustable feet and then use a Phillips
screwdriver to remove the bottom bracket.
Remove the pin retaining nut using a 10mm spanner.
Remove the pin, you may need to tap it to release it.
Turn the bracket over and replace it. Tighten securely. Refit the bracket on the opposite side of the door.
Tighten securely. Remove the blanking plate on the top of the
refrigerator and replace where the bracket was
removed. Replace the door.
Remove the blanking plate from the hinge hole and
replace it on the opposite side of the door. Attach the top hinge bracket using the two screws.
Replace both adjustable feet.
Check the door is aligned
horizontally and vertically.
Re-adjust the levelling
feet. See ‘Levelling the
refrigerator’ on page 4.
• Ensure the refrigerator is unplugged and empty.
• We recommend you have someone to assist you.
Tools required
• Phillips style screwdriver.
• Flat bladed screwdriver.
• 8 and 10 mm spanner or socket.
Before you start lay the refrigerator on its back in
order to gain access to the base. You should rest
it on soft foam packaging or similar material to
avoid damaging the cooling pipes at the rear of
the refrigerator.
1 2 3
4 5
6 7
8 9 10 11
Replace the cover, it should be pushed into place
from the rear.
Use a Phillips screwdriver to remove the two screws
holding the bracket in place and remove. Place to
one side. Lift the door away from the refrigerator.