background image

4

GETTING TO KNOW YOUR REFRIGERATOR

Location

When selecting a position for your refrigerator, you should make sure the floor is flat and firm, and the room is 
well ventilated with an average room temperature of between 16°C and 38°C. Avoid locating your refrigerator near 
a heat source, eg. cooker, boiler or radiator. Also avoid direct sunlight.  

Never place the refrigerator in a wall recess or into fitted cabinets or furniture. When your refrigerator is working, 
the grille at the back may become hot and the sides warm. It must therefore be installed so that there is at least
10cm of free space at each side and above the unit and a minimum of  7.5cm from the back of the r   

There is a built in flow grille at the back of the refrigerator to ensure the correct distance from the wall.

efrigerator and the wall.

lid to ensure the correct distance from the rear wall. The refrigerator door can either open to the right or the left, 
depending on the location which suits you. See page

 6 

if you want reverse the door swing. Do not drape the fridge 

with any covering.

Levelling the refrigerator   

Once the refrigerator is put in its final location, make sure it is level. To do this use the  
two levelling feet at the front of the refrigerator. If the refrigerator is not level, the 
doors and magnetic seal alignments will be affected.

Cleaning before use

Wipe the inside of the refrigerator with a weak solution of bicarbonate of soda. Then rinse with warm water using  
a wrung-out sponge or cloth. Wipe completely dry before replacing the shelves and baskets. You could clean the 
refrigerator externally with wax polish. If you require more information, refer to CLEANING on page  7.

Before plugging in YOUMUST

Check that you have a socket which is compatible with the plug supplied with the refrigerator. If not, see the 

.

0

1

 

e

g

a

p

 

n

o

 

S

N

O

I

T

C

E

N

N

O

C

  

 L

A

C

I

R

T

C

E

L

E

 

d

e

l

l

a

c

 

n

o

i

t

c

e

s

Before switching on!

DO NOT SWITCH ON UNTIL TWO HOURS AFTER MOVING THE REFRIGERATOR 

. The coolant fluid needs time to settle.

Before using your refrigerator

Before placing any food in your refrigerator, turn the refrigerator on and wait for 24 hours, to make sure it is 
working properly and to allow the refrigerator to fall to the correct temperature. 

Before use

Please read these instructions carefully before using your new Fridgemaster  
refrigerator. The refrigerator is for indoor and domestic use only.

THERMOSTAT

SHELF

BOTTLE STORAGE

LEVELLING FEET 

SALAD BIN

ICE COMPARTMENT

INSTALLATION

Please keep these instructions in a safe place for future reference.

Ensure that there is sufficient clear space in front of the refrigerator to allow the door to open 160º.

Summary of Contents for MUR49100













Reviews: