Fridgemaster MTZ55139FF, Instruction Manual, Page: 10 / 12

Before you start lay the refrigerator on it’s
back in order to gain access to the base,
you should rest it on soft foam packaging or
similar material to avoid damaging the
cooling pipes at the rear of the refrigerator.
1.Remove the four blanking plates from the
top of the freezer with a flat bladed
screwdriver.Remove the screws underneath
with a Phillips screwdriver.
Reversing the door
The side at which the door opens can be
changed from the right side (as supplied) to
the left side, if the installation site requires.
Tools you will need:
1. 8mm socket driver and 10mm
2. cross-shaped screwdriver
3. Putty knife or thin-blade screwdriver
socket driver
10
2.Use the 8mm socket or spanner to remove
the three bolts above the door hinge.Lift off
the bracket. Remove the freezer door.
3.Remove the pin from the bracket and
replace it into the same hole from the other
side.
4.Remove the hinge insert plate from the
bottom of the freezer door.Replace the plate
on the opposite side.
5.Tilt the freezer back,no more than 45°,to
access the bottom hinge and feet.Remove
the feet and the bolts securing the right hand
hinge plate and left hand fixing plate.
6.Remove the pin from the position 1 and
replace it in position 2.Place the hinge on
the opposite side of the cabinet,secure it
with three bolts,screw the foot into position.
7.Place the fixing plate on the opposite side
of the appliance,secure it with three
bolts,and screw the foot into position.
4. Monkey wrench