![Fridgemaster MTTZ4430 Instruction Manual Download Page 4](http://html1.mh-extra.com/html/fridgemaster/mttz4430/mttz4430_instruction-manual_2332610004.webp)
GETTING TO KNOW YOUR FREEZER
INSTALLATION
Location
Levelling the Freezer
Remove the packaging support from the Freezer. Check that the Freezer is placed on a
level and stable surface. To make sure the Freezer is level adjust the Levelling Foot at
the front. If the Freezer is not level, the doors and magnetic seal alignments will be
affected.
Cleaning before use
Wipe the inside of the Freezer with a weak solution of bicarbonate of soda. Then rinse with warm
water using a ‘wrung-out’ sponge or cloth. Wipe completely dry before replacing the baskets. You
could clean the Freezer externally with wax polish. If you require more information refer to DEFROSTING
& CLEANING the Freezer on page 8.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the Freezer. If not, see
the section called ELECTRICAL CONNECTIONS on page 10.
The coolant fluid needs time to settle.
Before switching on!
DO NOT SWITCH ON UNTIL TWO HOURS AFTER MOVING THE FREEZER.
Before using your Freezer
Before placing frozen foods in your Freezer, switch on the Freezer and wait for 24 hours, to make sure it is
working properly and to allow the Freezer to fall to the correct temperature. Your Freezer should not be
overfilled.
Before use
Please read these instructions carefully before using your new Fridgemaster Freezer.
The Freezer is for indoor, domestic use only. Please keep this instruction manual
in a safe place for future reference.
ADJUSTABLE FOOT
ICE CUBE TRAY
REMOVABLE SHELF
4
THERMOSTAT
CONTROL DIAL
(Back bottom Corner)
between 16ºC and 38ºC. Avoid locating your Freezer near a heat source, e.g. cooker, boiler or radiator.
Also avoid direct sunlight. When your Freezer is working, the side panels may become hot
and so to allow adequate ventilation there must be a space of at least 10cm between the
When selecting a postion to place your Freezer you should make sure that the surface is flat
and firm, and the room is dry and well vetilated with an average room temperature of
sides and 7.5cm from the back of the Freezer and any adjacent wall or cupboard. A space of at least 10 cm
must be left between the top of the Freezer and any cupboard, work surface or low ceiling above it.
Do not drape the Freezer with any covering
.
Summary of Contents for MTTZ4430
Page 1: ...How to use your new Model MTTZ4430 Freezer...
Page 2: ......
Page 11: ...NOTES 11...
Page 12: ......