SIRe Advanced Air Curtains Electric
32
GB
FF
FF
FF
Main menu
System on/off
Fan control
Installer menu
Main menu>Installer menu
Enter password
(See manual)
0 0 0
0
>Installer menu
Installer status screen
Week program
Installer status screen
Week program
>Installer menu>Week
program
Change program
New program step
Check program
Check program
Tue Wed Thu Fri
Sat Sun
Mon
08:00
18:00
Day (1)
Night (2)
Fan settings
Fan settings
2°C
002
Adv.
Comfort
Flexible
-
Auto
AC10
Installer status screen
Functionality mode
Eco / Comfort mode
Door mode
Current stage
Over run mode
Program
>Installer menu
Tue 10:45
00
:00
Tue 10:45
>Installer menu>Week
program
Check program
Week program on/off
New program step
Check program
Tue Wed Thu Fri
Sat Sun
Mon
08:00
18:00
Day (1)
Night (2)
>Installer menu>Week
program
Remove program
Check program
Change program
>Installer menu>Week
program
Change program
Check program
Remove program
Remove program
Reset all
Remove single
Remove all
New program step 7/16
Mode
Day
Tue 10:45
Tue Wed Thu Fri
Sat Sun
Mon
Tue 10:45
Tue
Wed
Thu Fri
Sat Sun
Mon
End
Tue 10:45
00
:00
Tue 10:45
Change program
Tue 10:45
Tue Wed Thu Fri
Sat Sun
Mon
Tue 10:45
Tue
Wed
Thu Fri
Sat Sun
Mon
End
Tue Wed Thu Fri
Sat Sun
Mon
1. 08:00
2. 18:00
3. 10:00
4. 16:00
Night
Day
Night
Day
Installer menu
To enter the Installer menu, code 1932 is entered.
Select the digits using the rotary dial and confirm
using the forward arrow.
To check which days a certain program is active,
select a week day by pressing the forward arrow,
the program is marked and those days that
the program is used will be underlined, switch
between the programs for a particular day using
the rotary wheel.
Installer status screen
Check the settings. The installer status screen
consists of three pages with settings, scroll using
the rotary dial.
Week program
Make settings for week program.
A basic program is pre-entered in SIRe.
Mon-Fri Day from 08:00, Night from 18:00
Sat Day from 10:00, Night from 16:00
Sun Day from 11:00:00, Night from 14:00
To check which program is set for a particular day,
select Check program and then switch between
the days using the rotary dial.
To add program step, select New program step.
Confirm your selection with the forward arrow.
Select Day, Night or Off (if the unit should not be
in operation), set the time for switch on and then
for which days the program applies, then go to
End to finish.
A new program step does not replace a set time
for Day for example, but you can instead select to
change a program step.
To change a program step, select Change program.
The program steps that should not apply are
removed in Remove program. One or all program
steps can be removed in the menu. To return to
the factory set basic program, select Reset all.
