Bench heater SH
4
GB
Area of use
Bench Heaters are designed for mounting
underneath church pews, waiting-room
benches, etc. The heaters are dimensioned
to emit comfortable heat to the seat itself,
the floor beneath it, and the air around the
bench, thereby making it possible to preserve
the relative coolness of the church while
the heating comfort for the visitors remains
excellent.
The heaters are
marked and comply with
the EMC directive. Protection class IP 20 for
use in dry rooms.
Mounting
The heaters shall be mounted horisontally
with the included mounting brackets. The
holes in the brackets is ø6 mm and a c -c
distance of 90 mm. Mount the brackets
underneath the bench and then fit the heater
into the brackets.
Fix the heater to the brackets by using the
the premounted screws on the bracket. The
brackets can be mounted with a flexible c-c
distance.
Note! The heater may not be angled or
pointing upwards.
Electrical installation
The electrical installation should be carried
out by a qualified electrician in conformity
with prevailing regulations. The appliance
should be preceded by a triple pole switch
with at least 3 mm breaking gap. The
connection box contains terminal blocks,
5x4 mm². This makes it possible to connect
several heaters in parallel. In the connection
box there are two knockouts ø18 mm
.
Connection 230V~:
The heating element is connected by using
terminal L1 and N. L2 and L3 are only used
for parallel connection to the next heater.
Connection 400V~:
The heating element is connected by using
terminal L1 och L2. L3 and N are only used
for parallel connection to the next heater.
Overheating
NOTE! The unit must not be covered fully or
partially with clothes or similar materials,
asoverheatingcanresultinairerisk!
Safety
• Notethemimimumdistancesintheigure
onpage2.
• Thespaceunderthebenchmayonlybe
completely covered on two sides.
• Theheatermustnotbeittedimmediately
below permanent electrical wall sockets.
Assembly and operating instructions
