Sipura SPA-841
Automatic Configuration Instructions
Step 1: Connect the Sipura SPA-841 to your broadband
connection
1.
Connect the SPA-841 to your network via Ethernet and attach the power connector to
the rear of the phone.
Step 2: Verify & Configure your IP Address
First we need to verify that your SPA-841 will acquire an IP Address automatically if
your network supports DHCP.
If your network uses a DHCP Server to assign IP Addresses to network devices, or if you are
connecting the SPA-841 to a home router such as a Linksys or Netgear router or a modem
that supports DHCP/NAT, please do the following:
1.
Press the phone's
i
button, located at the bottom right corner of the keypad. This
brings up the phone's configuration menu.
2.
Press
9
to enter the network configuration area.
3.
Check that
DHCP Enable
is set to
Yes
.
4.
If DHCP Enable is set to
No
, turn it on: press
edit
, then
y/n
, then
ok
. To apply this
change, press
save
, type
12
and press
ok
; the phone will restart with DHCP enabled.
